Tuesday, April 22, 2014


The MOC303XM and MOC304XM devices consist of a AlGaAs infrared emitting diode optically coupled to a monolithic silicon detector performing the function of a zero voltage crossing bilateral triac driver. MOC3041.

They are designed for use with a triac in the interface of logic systems to equipment powered from 115 VAC lines such as teletypewriters, CTRs, solid-state relays, industrial controls, printers, motors, solenoids and consumer appliances, etc

  • Simplifies logic control of 115 VAC power
  • Zero voltage crossing
  • dv/dt of 2000 V/µs typical, 1000 V/µs guaranteed
Motorola used to make these then it was Infineon Technologies now Isocom also makes it

MOC3041 Zero Crossing Triac Output, 6 Pin

See the original Motorola Application below.

MOC3041 Zero Crossing Triac Output, 6 Pin

These were used by me to make solid state relays. Look at the circuits here Power Electronics Circuits. The were used to control Heaters from DC control signal from a Proportional Temperature Controller. The Magnetic Contactors can be avoided for lower powers. At higher powers SCR banks become a bit expensive.

OC3041M: 6-Pin DIP 400V Zero Crossing Triac Driver Output Optocoupler

The SSR has no mechanical wear and tear but heat up at high currents. So if we overrate by 5 Times then it is an excellent solution for lower power controls upto 5 Kilo Watts. The cycle time of Contactors must be 20-60 Seconds to make it last long. In a SSR a one second cycle time is possible as 10-20mS is the switching speed due to zero crossing.