Tuesday, September 19, 2017

The Electronics Index of J. B. Calvert

Many may already know about these EE Educational pages with Circuits of J. B. Calvert.  These pages are valuable as they are like a summation of Important and Practical Sections in many EE Subjects. If you want to master the basics of EE, these pages will propel you in the right direction.

A Welath of Information is at the site - Dr James B. Calvert Associate Professor Emeritus of Engineering, University of Denver and Registered Professional Engineer, State of Colorado. An EE-Encyclopedia Almost.

Engineering and Technology - James B. Calvert
"An extensive series of pages based on experiments that can be done in the personal or home laboratory. The emphasis is on enjoyment and intellectual pleasure, but there is much practical matter as well."

Electronics Index - Includes vacuum tubes and cathode-ray tubes, with many experiments for the home laboratory. Nixie clocks too.

The Electronics Index of J. B. Calvert

The Atmel AVR microprocessors are very similar functionally to the PIC microprocessors, with the same range in size from 8-bit, 8-pin PDIP to 32-bit processors with 100 pins, and similar features.
Atmel AVR 8-Bit Microcontrollers


The ATtiny13A will operate from a supply voltage as low as 1.8V (maximum clock speed 4 Mhz), and with a full 20 MHz clock speed at 4.5V and above. The current drain is much reduced at the lower supply voltages and clock frequencies.

A Magnetometer
It is easy to measure moderate magnetic fields using a Hall sensor, such as the Allegro A1302 linear Hall sensor, available from Jameco. A PIC12F675 can digitize the output of the sensor and display it on a serial LCD display, such as the Newhaven NHD-0216K3Z-FL-GBW 2 line x 16 digit display. This system is shown breadboarded in the figure at the right, measuring the field between the poles of a horseshoe magnet.

Monday, September 18, 2017

KTechLab - Open Source IDE

KTechLab project. KTechLab is a an IDE for microcontrollers and electronics. It supports circuit simulation, program development for microcontrollers and simulating the programmed microcontroller together with its application circuit. Ktechlab was developed by David Saxton.

KTechLab - Open Source IDE

KTechLab - Open Source IDE

Integrated Design Environment (IDE) for electronic and PIC microcontroller circuit design and simulation. Featuring an extensive circuit designer with autorouting and simulation of many common electronic components and logic elements, KTechLab is the idea tool for educational or hobbyist use. You can simulate analog circuits and logical circuits using KTechLab.

You can write programs using Assembly, C (SDCC), or Flow Code - program the microcontroller(PIC) using flowchart. Another option is Microbe a programming language like BASIC.

KTechLab supports a wide range of Open Source PIC programmers, enabling finalised PIC programs to be quickly and easily transfered to a real PIC microcontroller.

Tuesday, September 12, 2017

Kenneth Wyatt - EMC design and training services

A consulting firm that specializes in EMC design, troubleshooting and training services to commercial and industrial manufacturers with global distribution in the consumer, computer, network & telecommunications, industrial and scientific industries.

Kenneth Wyatt -  EMC design and training services

Kenneth Wyatt -  EMC design and training services

DIY 6 GHz comb generator by Kenneth Wyatt

Most simple DIY comb generators seem to run out of steam about 1 GHz. I recently ran into David Bowman’s 2.4 GHz circuit and measured an upper usable range of about 6 GHz. While greatly attenuated above 3 GHz, this circuit should still be valuable for measuring semi-anechoic chambers in the GHz ranges.

Wyatt Technical Services, LLC
56 Aspen Dr. Woodland Park, CO 80863, USA

Blocks

80C51 Analog Analog-Design Analytical-Instrumentation Android Application-Notes-2 ASIC-Design ASIC-SOC-FPGA Bipolar-Transistors Capacitors Circuit-Archive Circuit-Design Circuit-Design-2 Communications Communications-Chips Component-Testing Computer-IC-Module Computer-Interfacing Control-Systems Design-Service Design-Service-2 Design-Service-3 Digital Discrete-Semiconductors DSP EDA EDA-2 EDA-3 EDA-4 EDA-5 Educational Educational-2 Electrical Electromechanical Embedded Embedded-2 Embedded-Applications Embedded-Systems-Tools Energy-Power Engineering-Services Engineering-Services-2 Engineering-Services-3 ESD-EMI-RFI Firmware Home-Automation Industrial-Automation IoT-WSN-M2M LED-Lighting Magazines Manufacturing-Services Materials-Nanotech Mechanical-3D-CAD Mechatronics Medical-Electronics MEMS Microcontroller Microelectronics Mixed Mixed-Semiconductor Mixed-Signal-Design Opamps Open-Hardware Optoelectronics Organizations-Associations Passive-Components PCB-Layout Photonics-Optics PIC Power-Devices Power-Electronics Power-Electronics-Design Process-Control Process-Control-2 Product-Safety Product-System-Design Projects Quality Reference Research-Institutes RF-Components RF-Design RF-Engineering-Services RF-Microwave RF-Semiconductor RF-Wireless-Networking Robotics Scientific-Software Semiconductors Sensors SMPS-Power-Supply Software-Code Spice-Simulation Standards Standards-2 Tech-Docs Tech-Media Technical-Computing Test-Measurement TM-Applications Training-Consulting Virtual-Instrumentation